INSTALLATION
15
Attach Hold-Down Brackets (Optional)
Reveal
®
with MagnaView
®
Blinds
Hold-down brackets for the Reveal
®
with MagnaView
®
blinds may only be used with outside-
mounted blinds.
■
Fully lower the blind and
completely open the slats.
■
Mount the hold-down brackets
to the outside mounting
surface with the bottom of the
slot aligned with the center
of the perforated hole on the
bottom rail end caps.
■
Screw the washer head and
Philips screw through the slot in the bracket and into the perforated hole, leaving enough
gap for the screw to slide freely up and down the slot.
Natural Elements
™
with MagnaView Blinds
■
Drill a
3
/
32
" hole centered in the ends of the bottom rail.
■
Insert a hold-down pin into each hole. Push the head of the pin against a flat surface to seat
it, or tap in place with a hammer.
■
To mount the hold-down brackets, first fully lower the blind. Align the hold-down brackets
with the pins in the bottom rail.
➤
Align the pins with the second slot.
■
Maintain the second slot alignment as you attach the hold-down brackets to the jamb, sill or
outside mounting surface.
■
Slide the hold-down pins into the second slot on the brackets.
■
When the bracket is mounted horizontally for outside mount (as shown on the right side of
the figure below), the first slot may be used if it provides the best alignment with the pin.
This might negate the need to use a spacer block.
Jamb
Mount
Second
Slot
First
Slot
Sill
Mount
Outside Mount
Natural Elements
with MagnaView Blinds
Hole At
Bottom of Slot
Screw
Into Hole
Reveal with MagnaView Blinds
Jamb
Mount
Second
Slot
First
Slot
Sill
Mount
Outside Mount
Natural Elements
with MagnaView Blinds
Hole At
Bottom of Slot
Screw
Into Hole
Reveal with MagnaView Blinds
