OPERATION
17
Troubleshooting
Problem
The blind does not raise and lower evenly.
Solution
Check inside the headrail. Make sure no obstructions keep the mechanism from
turning. Check that the lift cords are not pinched or tangled.
Problem
The blind will not fit into the installation brackets.
Solution
Make sure the brackets are level and aligned, and the mounting surface is flat.
Problem
Lift cords are bunching by the safety cord stop
.
Solution
Make sure the slats are in the open position. Raise and lower the blind.
Problem
Lift cords are stuck or jammed.
Solution
Check the cords and the movable pin in the cordlock mechanism inside the
headrail of the blind. Make sure the cords can move freely. If the cords are
jammed, use a screwdriver or needlenose pliers to move the pin and free
the cords.
Problem
The lift cord is wrapped around the ladder tape.
Solution
Remove the plastic cap on the bottom of the blind that covers the cord rout hole.
Untie the knot in the lift cord and re-thread. Re-tie the knot and replace the cap.
Cord Tilt
Wand Tilt
Reveal
®
with MagnaView
®
Blinds
Raising and Lowering
Natural Elements
™
with MagnaView
Raising and Lowering
