INSTALLATION
12
Fascia Shades
ST30 brackets are shown, but ST50/LT525 assembly is the same process. Identify the
components.
■
Assemble the two end brackets and the fascia panel.
➤
Place the top of the fascia panel into the top indention of the
brackets. Rotate the panel down and snap it into place.
■
Check that the outer surfaces
of the brackets are flush with
the ends of the panel.
■
Hold the bracket and panel
assembly in place at
the window.
■
Use a level against the
bottom edge to make sure
the assembly is level. Inside
mounts may require a shim
between the brackets and the
mounting surface.
➤
For Outside Mount.
Use a pencil to mark the bottom and outside edges of the
brackets on the mounting surface.
➤
For Inside Mount.
Use a pencil to mark the outside edges of the brackets on the
mounting surface.
■
Remove the assembly from the window.
■
Remove the brackets from the fascia panel.
■
Inside Mount.
Use your marks to position each bracket and mark the screw holes.
➤
The minimum mounting depth required and fully recessed depth is 4
1
/
8
".
Front
Panel
Pencil Marks
(Inside Mount)
Pencil Marks
(Outside Mount)
Flush
Idle Side
Motor Side
Inside Mount
