ASSEMBLY
11
Connect the Power Source
NOTE:
When power is connected to the motor, a blue LED below the control button will flash
to indicate the shade is ready for operation.
■
Refer to the appropriate page based on your order.
➤
For battery wand (for 38" and wider shades), see below.
➤
For a satellite battery pack (for shades narrower than 38"), page 12
➤
For a satellite-mounted rechargeable battery wand, see page 20.
➤
For an optional 18V DC Power Supply, see page 13.
Battery Wand (If Applicable)
Install the Batteries into the Battery Wand
■
Squeeze the cap latch to release and remove
the cap.
■
Install AA Energizer
®
Ultimate Lithium batteries
according to the instructions on the battery
wand label.
■
Replace the cap.
➤
Align the tab with the end of the wand.
➤
Press the cap on until it latches.
Mount the Battery Wand into the Battery Wand Holder
■
Remove the bottom rail cover.
■
Align the battery wand with the socket toward
the motor.
■
Push the battery wand straight down into the
battery wand holder in the bottom rail.
CAUTION:
Be sure the cable does not become
pinched by the battery wand holder during
installation. Damage or overheating of components could result.
Plug the Power Cable into the Battery Wand
■
Connect the power cable into the socket on the battery wand.
➤
Make sure the cable is not wrapped around the shaft.
■
Reinstall the bottom rail cover.
Proceed to "Test the Shade" on page 14.
Tab
Slot
Cap
Latch
Battery
Wand
Squeeze
Battery Wand
Holder
Battery Wand
Summary of Contents for Applause
Page 33: ...CHILD SAFETY 31 ...