ASSEMBLY
4
■
Inside Mount shades only:
Light gap seals
should be inserted into the front channel of all
four rails. Make sure they are inserted in the
correct orientation, as shown.
■
Inside Mount shades only:
If the angle of the
installed shade will be 45° or steeper, slide two
spacer blocks into the rear channel on the underside
of the bottom rail. The spacer blocks prevent the light
gap seal from over-compressing and ensure even
positioning of the shade in the casement.
➤
Position the spacer blocks approximately one-
fourth the shade width from each end of the
bottom rail.
➤
The plastic spacer blocks have tabs of
1
⁄
2
",
3
⁄
8
",
and
1
⁄
4
". If necessary, break off the outer tabs to
adjust the spacer block to the appropriate size, so
the shade fits evenly into the casement.
NOTE:
The spacer blocks are packaged with the
corner covers.
Back
of
Shade
Front of Shade
Light Gap
Seal
Summary of Contents for Applause
Page 33: ...CHILD SAFETY 31 ...