ASSEMBLY
9
Insert the Bottom Tension Plates in Place
■
Place the bottom rail tension plate under the tension
cable bracket in the bottom rail on the left side.
➤
If you moved the tension cable bracket out of
the way, move it back against the bottom
corner bracket.
➤
If the tension plate does not reach the tension
cable bracket, check that the cable is not tangled
with the top corner bracket.
IMPORTANT:
Make sure the tension cable is in
the slot.
■
Locate the bottom tension plate screws in the
package, place the screw in the screw hole in the
left bottom tension plate and tighten it to keep the
tension plate in place.
■
Repeat the above steps on the right side.
■
If there are more than two tension cables:
Repeat the above steps for each tension plate.
Install the Bottom Rail Cover
■
Center the bottom rail cover on the bottom rail.
■
Angle the cover into the back groove then down.
■
Press the front of the cover into the front groove.
Tension
Plate
Tension Cable
Bracket
Tension
Plate
Tension Cable
Bracket
Summary of Contents for Applause
Page 33: ...CHILD SAFETY 31 ...
