INSTALLATION
15
Install the Shade — Inside Mount
Your order will include four installation brackets per shade and two mounting
screws per installation bracket, plus four extra screws.
Trim the Light Gap Seals
■
Trim the excess light gap seal at all
four corners with sharp scissors.
Mount the Installation Brackets
■
Starting with the bottom right
corner of the skylight opening, hold
the provided Honeycomb SkyLift
™
Inside Mount Bracket Template
with the arrow toward the glass.
■
Line up the front edge of the jamb
with the dotted line located at the
2
1
⁄
2
" mark on the template.
IMPORTANT:
If you are installing
a satellite battery pack behind the
bottom rail, line up the
front edge of the jamb with the
dotted line located
at the 4
1
⁄
2
" mark.
■
Mark the screw holes.
■
Use the same side of the
template for the top left corner
of the skylight opening.
■
Flip the template and use the
backside for the top right and
the bottom left corners.
■
After marking all four corners,
drill the screw holes using a
3
⁄
32
" drill bit.
■
Attach the installation brackets
using the screws provided.
Installation
Bracket
Installation
Brackets
Sill
Jamb
Summary of Contents for Applause
Page 33: ...CHILD SAFETY 31 ...