INSTALLATION
15
STEP 2 — Install the Shade
CAUTION:
The antenna attached to the motor is fragile. Be careful unwrapping and handling
the shade so antenna does not get damaged.
Your shade may be standard roll or reverse roll based on your order. Be sure to orient the
shade correctly before installing.
NOTE:
All shades install the same regardless of top treatment. For coupled shades the first
motor end shade will follow the steps below and the remaining coupled shades will install
using steps on “Coupled Shades” on page 17.
■
The shade should be wrapped tight with the paper banding in place. The bottom bar
should be positioned just below the fabric in either the standard or reverse roll position
based on your order.
■
Ensure the nut is in the install position, at the end of the idler.
CAUTION:
Do not install motor end first, idle end must be
installed first. Do not rotate the motor in the tube manually it
will damage the motor.
■
Push idle end of shade into the hole of the idle bracket,
compress the idler and bring up the motor end to
motor bracket
Wall or
Window
Room
Wall or
Window
Room
Standard Roll
Note: Shade are lowered for clarity. The shade should be wrapped tight with the paper banding in place.
Reverse Roll
Standard Roll
Bottom
Bar
Paper
Banding
Tube and
Shade
Fabric
Reverse Roll
Idler
Nut
Install
Position
Nut
Insert
Idle
End
Summary of Contents for Designer Roller
Page 31: ......