INSTALLATION
4
Attach the Side Tracks
WARNING:
Adhesive on the back of the side tracks is to be placed onto the
mounting surface one time only. Do not attempt to remove and re-apply the side
tracks. The adhesive will not provide full mounting strength once removed and
re-applied. If the side tracks are removed, new adhesive must be used. Failure to
properly use the side track adhesive may result in injury or property damage.
IMPORTANT:
Do not remove the adhesive backing yet.
■
Test fit the side tracks and check to ensure both
tracks are true vertical, using a level.
➤
The side tracks must be installed so that there
is at least
1
/
8
" space for the mounting bracket
between the top of the side track and any
obstruction above the side tracks.
➤
If the side tracks are installed outside of the
window opening, center the headrail over the
window opening at the desired height. Use a
pencil to lightly mark the mounting surface at
each end of the headrail. Make additional marks
along the tracks, if needed.
➤
If the side tracks are not vertical, mark on the
mounting surface so that the tracks are installed
perfectly vertical.
■
Remove the adhesive backing from the left side track.
■
Starting from the bottom, attach the left side track
to the left side of the window opening.
➤
Be sure the track is perfectly vertical.
➤
The rail clip should point to the right, as shown.
Side Track
