HunterDouglas Duolite Shades, Installation Operation Care

OPERATION

13

Further Operation and Programming Information 

PowerView Pebble

®

 Remote and/or PowerView Surface Remote 

Operation

For information regarding operation and programming of the PowerView remote, refer to your 
PowerView Automation Remote Control Guide or to the online PowerView Step-by-Step Guide at 

hunterdouglas.com/operating-systems/motorized/powerview-motorization/manuals

.

PowerView Scene Controller

For information regarding operation and programming of the PowerView Scene Controller, refer 
to your PowerView Automation Scene Controller Guide or to the online PowerView Step-by-Step 
Guide at 

hunterdouglas.com/operating-systems/motorized/powerview-motorization/

manuals

.

PowerView App Operation

The PowerView Hub is required for PowerView App operation. For information regarding setup 
and operation using the PowerView App, refer to the online PowerView Step-by-Step Guide at 

hunterdouglas.com/operating-systems/motorized/powerview-motorization/manuals

.

Resetting the Shade (If Necessary)

Calibration Reset

The calibration reset is used to recalibrate the shade’s travel limits.
1. Press and hold the programming button for approximately 6 seconds. The shade will move 

slightly. Release the programming button (the light flashes red).

2. Both the front shade and back panel will raise to their fully open positions to reestablish the 

upper travel limit, then lower to their fully closed positions to reestablish the lower travel limit. 
The back panel will then move slightly twice (up, then down) to indicate that the travel limits 
were recalibrated.

Resetting Shade Programming

The programming reset erases all shade programming from memory, including group assignments, 
preventing input devices from operating the shade. The primary use is to correct group and 
network assignments during installation. The reset does not affect travel limits or the favorite 
position.
1. Press and hold the programming button for approximately 12 seconds. The shade will move 

slightly after 6 seconds, then again after 12 seconds. Release the programming button (the 
light flashes red). The light then flashes a series of green and red to indicate that shade 
programming is erased from memory.

2. Refer to “Joining a Shade to a Group” on page 12 to program the shade to a group.