HunterDouglas Duolite Shades, Installation Operation Care

DECLARATIONS

18

U.S. Radio Frequency FCC Compliance

FCC ID information is located behind the motor-side headrail end cap. The end cap may be removed to 

view this information.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:  

(1) This device may not cause harmful interference, and  

(2) This device must accept any interference received, including interference that may cause undesired 

operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses and can radiate radio frequency 

energy and, if not installed and used in accordance with the instructions, may cause harmful interference 

to radio communications. However, there is no guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference to radio or television reception, which 

can be determined by turning the equipment off and on, the user is encouraged to try to correct the 

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected.

• Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void 

the user’s authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment 

and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and 

operated keeping the radiator at least 20 cm or more away from person’s body. RF Exposure requirements 

are met when installed in mobile equipment. This module cannot be installed in portable equipment 

without further testing and a change to FCC’s grant of authorization.