OPERATION
5
Test Headrail Operation
■
Use the manual control button on the motor to test the operation of the headrail, following
the sequence below.
1. Press and hold the manual control button for 6
seconds. The sheer will move slightly.
2. Release the manual control button. The sheer
will move to its fully open position to set the
OPEN travel limit, then move to the fully closed
position to set the CLOSE travel limit. Next, the
vanes will rotate counter-clockwise and then
clockwise to set the rotation limits. The sheer
will move slightly one more time to indicate that
the travel limits have been set.
NOTE:
There could be up to an 8 second pause between the vanes tilting from counter-
clockwise to clockwise.
■
Pressing the manual control button while the carriers are traversing or the pinion clips are
rotating will stop the action. The next button press will traverse the carriers or rotate the
pinion clips in the opposite direction.
Using the PowerView
™
Remote
First, activate the remote by pulling both plastic tabs from the back battery compartment.
IMPORTANT:
If you have more than one remote, see “Adding Additional Remote(s) to the
PowerView
™
Shade Network” in the
PowerView Motorization Remote Control Guide.
Manual
Control
Button
Group 1
Group 2
OPEN
CLOSE
Group 3
Group 4
Group 5
Group 6
Favorite
(Sheer/vane position)
LEFT ARROW
Rotates vanes clockwise
RIGHT ARROW
Rotates vanes counter-clockwise
STOP
(Press and hold for
programming mode)
