OPERATION
18
Joining a Shading to a Group
IMPORTANT:
The shading will not operate using the remote until it has been joined to a group.
1. Press and hold
■
STOP for 4 seconds to put the remote in program mode. The lights on the
remote will flash to indicate it is in program mode.
2. Press the desired group number (1 – 6) on the remote. The backlight for the group number
will flash to show it is selected.
3. Press and hold the manual control button on the shading.
4. While continuing to press the manual button, press
▲
OPEN on the remote. The shading will
move slightly to indicate it has joined the group. Release the manual control button.
5. Press and hold
■
STOP for 4 seconds to exit program mode. The lights will stop flashing.
Basic Operation
1. To wake up the remote, simply pick it up or press
■
STOP. The last group(s) selected will be
highlighted and active.
2. Press “all” or groups 1 – 6 to select specific shading(s) to move. Selected group button(s) will
light to show they are selected.
a. Multiple group buttons may be selected at a time.
b. To deselect a group, press the group button again. The backlight for that group button
will go out.
3. Press
▼
CLOSE to lower the selected shading(s).
4. Press the right arrow to open the vanes.
5. Press the left arrow to close the vanes.
6. Press
▲
OPEN to raise the selected shading(s).
7. Press
■
STOP to stop shading or vane movement anywhere along its travel.
8. While a shading is in motion, press the opposite of shading motion (
▲
OPEN or
▼
CLOSE) to
reverse direction.
9. Press
♥
FAVORITE to send selected shading(s) to your preset “favorite” position. Refer to the
PowerView
™
Motorization Remote Control Guide
on how to set a favorite position.
Operating Tips
1. When the shading is raised, pressing the right arrow will first lower the shading and then
open the vanes.
2. When the shading is lowered with the vanes open, pressing
▲
OPEN will first close the vanes
and then raise the shading all the way.
