INSTALLATION
15
Attach the Valance with Universal Valance Clips
■
Tilt the valance to insert its bottom notch into the bottom part of the clips.
■
Pulling the valance slightly downward, insert the top notch of the valance into the clips,
as shown.
■
To remove the valance, gently pull the valance downward to release it from the top of the
clips. Rotate the top of the valance toward you. Lift up the valance to release it from the
bottom of the clips.
Attach the Hold-Down Brackets (Optional)
■
For a wood bottom rail, the bottom rail will come with pre-drilled
3
⁄
32
" holes and
hold-down pins that have been inserted in the center of the bottom rail ends. For an
aluminum bottom rail, push out the perforated pin plug from each bottom rail end cap
using a ballpoint pen or similar pointed object.
NOTE:
Bottom rail design varies by product.
■
To mount the hold-down brackets, first fully lower the blind. Align the hold-down brackets
with the pins in the bottom rail.
➤
Align the pins with the second slot.
■
Maintain the second slot alignment as you attach the hold-down brackets to the jamb, sill,
or outside mounting surface.
■
Slide the hold-down pins into the second slot or hole on the hold-down brackets.
■
The first slot of the hold-down brackets may be used in place of a spacer block.
Bottom
Notch
Top
Notch
Bottom
Notch
Top
Notch
Reveal
®
with MagnaView
®
Decorative Valances
Aluminum Natural Elements
™
Blinds Artemis
™
Valances
Jamb
Mount
Second
Slot
First
Slot
Sill
Mount
Outside Mount