INSTALLATION
16
Operate the Blind
Tilting the Slats
After installation, tilt the slats from fully closed in one
direction to fully closed in the other. Repeat three or four times
to calibrate the tilt mechanism to ensure proper stacking.
■
Wand tilt (not shown):
Rotate the wand to tilt the slats to
the desired angle.
■
Cord tilt:
The two cords with individual tassels are for tilting
the slats. Each cord tilts the slats in an alternate direction.
Raising and Lowering the Blind
IMPORTANT:
Whenever raising or lowering the blind, the slats must be in the open position.
■
Pull the single cord down and toward the center to raise and lower.
■
Hold the single cord to the outside to lock the blind in position.
Raise and
Lower
Lock into
Position
