HunterDouglas Pirouette PowerView, Installation Operation Care

DECLARATIONS

26

U.S. Radio Frequency FCC Compliance

FCC ID information is located on shading behind the end cap cover. The end cap cover may be removed by hand 

to view this information.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:  

(1) This device may not cause harmful interference, and  

(2) This device must accept any interference received, including interference that may cause undesired 

operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 

interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy 

and, if not installed and used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a particular installation. If 

this equipment does cause harmful interference to radio or television reception, which can be determined by 

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the 

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the 

user’s authority to operate the equipment.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and 

meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and operated 

keeping the radiator at least 20 cm or more away from person’s body. RF Exposure requirements are met when 

installed in mobile equipment. This module cannot be installed in portable equipment without further testing 

and a change to FCC’s grant of authorization.

Industry Canada

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type 

and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio 

interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically 

radiated power (e.i.r.p.) is not more than that necessary for successful communication.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the 

following two conditions: (1) this device may not cause interference, and (2) this device must accept any 

interference, including interference that may cause undesired operation of the device.

Class B Digital Device Notice

This Class B digital apparatus complies with Canadian ICES-003, RSS-Gen and RSS-210. 
CAN ICES-3 (B)/NMB-3(B)
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment and meets 

RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment should be installed and operated keeping 

the radiator at least 20 cm or more away from person’s body.

European Conformity

We, the undersigned,
Hunter Douglas Window Fashions 

One Duette Way, Broomfield, CO 80020, USA
Hunter Douglas Europe B.V. 

Piekstraat 2, 3071 EL Rotterdam, The Netherlands
certify and declare under our sole responsibility that assembly PV13 conforms with the essential requirements 

of RED 2014/53/EU.
A copy of the original declaration of conformity may be found at:  

www.hunterdouglas.com/RFcertifications

.