INSTALLATION
10
Adjust Headrail Tightness
If the headrail is loose in the end brackets, bend the tabs on
■
the end brackets outward.
Important:
The tabs may also be bent inward if the
headrail is difficult to install into the end brackets.
If your headrail end brackets do not have adjustable tabs,
■
bend the tabs on the headrail end locks to adjust headrail
tightness.
Close End Brackets
Push the cover down until it snaps over the locking tab on
■
the bottom of the bracket.
Open End Brackets
To open the end brackets, insert a flathead screwdriver
■
between the bottom of the cover and the quick release tab,
and twist.
You can also push up on the bottom of the bracket to
■
release the locking tab.
Mount the PowerTilt
™
Components
After the blind is installed, mount the PowerTilt components.
Satellite Battery Pack
Determine where to mount the satellite battery pack.
If mounting the satellite battery pack outside the headrail, install the blind first.
■
If mounting the satellite battery pack inside the headrail, install the battery pack before
■
installing the blind,
see page 11
.
notes:
With the battery pack inside the headrail, the blind must be removed from the
window to change batteries (battery life is approximately two years, depending on usage).
The battery pack must be mounted outside the headrail on alternative wood blinds
with cable tapes between 30" - 33" wide and between 30" - 35" wide on wide-tape blinds.
