INSTALLATION
11
Mounting the Satellite Battery Pack
Outside the Headrail
Mount the battery pack in a location where it will
not interfere with the operation of the blind.
Outside Mounts.
■
Route the wire so it exits from
the top of the blind.
Inside Mounts.
■
Route the wire so it runs along
the motor side end bracket to the front of the blind.
Install the satellite battery pack housing.
■
Remove the cover of the battery pack by pressing
➤
on the circular latch and lifting the cover off.
Use the holes in the rear of the housing as a
➤
template to mark the screw locations on the
mounting surface.
Attach using two screws (included).
➤
Load batteries into the satellite battery pack.
■
Install eight AA alkaline batteries according to the
➤
instructions on the battery pack.
Replace the cover, snapping it securely closed.
➤
tIp:
The satellite battery pack cover may be painted to
match the wall color.
Mounting the Satellite Battery Pack
Inside the Headrail
Load batteries into the satellite battery pack (see instructions above).
■
Mount the battery pack inside the headrail in a location where it will not interfere with the
■
operation of the blind. Position its smooth, curved side toward the tiltrod.
Carefully tuck excess wire into the headrail. Be sure to avoid any moving parts.
■
Inside Mount Blind
Outside Mount Blind
Loading Batteries
Tiltrod
Satellite Battery Pack
Back of Headrail – Overhead View
Motor Housing
To Satellite
Eye
