INSTALLATION
4
Attach Spacer Blocks (2
1
/
2
" and 2
5
/
8
" Slat Sizes)
Spacer blocks are optional for 2" slat sizes.
Attach a spacer block to each of the two end
■
brackets.
If one or more intermediate brackets is required,
■
attach a spacer block to each intermediate bracket.
If extension brackets will be used, do
■
not
use
spacer blocks.
Mount the End Brackets – Inside or Ceiling Mount
With inside mounts or ceiling mounts, attach the two
end brackets flush against the sides of the window
casement or the ceiling. Use a
3
∕
32
" drill bit to drill
holes for the mounting screws. Choose the most
appropriate of the following four mounting methods:
Side mount the brackets with one screw
■
through a side hole and one screw through
a top hole, as shown.
If the brackets are flush with the back wall,
■
attach them with one screw through a top
hole and one through a rear hole.
Top mount the brackets with screws
■
through the two top holes.
If limited mounting depth is available, the bracket
■
may be mounted with two screws through
diagonal side holes.
Important:
For blinds with 2
1
/
2
" or 2
5
/
8
"
slats, spacer blocks are used with inside mounts
to position the brackets a minimum of
3
/
8
" from
the glass. This prevents slats from rubbing the
glass when tilting or when the blind is raised and
lowered.
Important:
Spacer blocks are optional for 2" slat sizes.
End Bracket
Intermediate Bracket
Side
Mount
Top
Mount
Side
Mount
Top
Mount
