1
For assistance, call the Hunter Douglas
Customer Information Center
at 1-888-501-8364
7:00 AM to 4:30 PM MST, Mon.-Fri.
Visit our Web site at hunterdouglas.com
7"– 10"
7"– 10"
Space Evenly
(60" Maximum)
Space Evenly
(60" Maximum)
Headrail
Outside Mount Applications
A flat vertical surface at least
5
/
8
" high is required to mount the
installation brackets.
Outside Mount Bracket Attachment
• Attach the installation brackets with two screws through the two
holes in the rear of the brackets.
• Use a carpenter’s level to check that the tops of the brackets are
aligned at the same height before tightening the screws.
Inside Mount Bracket Attachment
• Attach the installation brackets with two screws through the
two holes in the top of the brackets.
• Be sure the front edges of the brackets are aligned before
tightening the screws.
Inside Mount Applications
Use a carpenter’s level to check that the mounting surface is perfectly
level. Shim the installation brackets, if necessary.
• Minimum casement depth for bracket attachment is
7
/
8
".
• To fully recess the blind, a depth of 1
3
/
4
" is required.
7
/
8
" Minimum Depth
Bracket Attachment
1
3
/
4
" Depth
Fully Recessed
Inside Mount
5
/
8
" Minimum
Flat Vertical Surface
Outside Mount
Mount the Brackets
Bracket Spacing
• Position the two end brackets on the mounting surface so that
they will be located between 7" and 10" from the ends of the
headrail.
• If more than two brackets are required (see chart below), space
the additional bracket evenly between the end brackets.
IMPORTANT: Do not position any bracket where it will be
located directly above a string ladder or cordlock.
Labels
have been placed on the headrail for guidance. Allow 1"
space on the side whenever possible.
Extension Brackets (Optional)
Extension brackets can be used with outside mounts to project the
installation brackets from 2
3
/
4
” to 4
1
/
8
” from the mounting surface.
This allows for additional clearance of obstructions such as window
cranks or handles.
• The extension brackets may be fastened together two different
ways to produce the desired wall extension, as shown below.
• Attach the extension brackets using #6 self-tapping screws.
• Mount the extension bracket assemblies to the window frame or
wall using two diagonally located screws.
• Use appropriate fasteners to bolt the mounting brackets to the
extension brackets.
Mount with Two Screws
Through Diagonal Holes
2
3
/
4
" to 3
1
/
8
" Projection
3
5
/
8
" to 4
1
/
8
" Projection
No. 6 Self-Tapping
Screws
3
/
8
" Long
Number of Brackets Required
Width of Blind
7" - 60"
2
60
1
/
8
" - 120"
3
Over 120"
4
