HunterDouglas Silhouette Duolite Window Shadings PowerView Motorization, Installation Operation Care

OPERATION

18

Change the Closed Vane Adjustment Position

The closed vane adjustment position is set for each shading at the factory and normally does 
not require readjustment. Use the following instructions to reset the position for shadings that 
may need additional adjustment. The objective is to get the longest drop of the shading with the 
vanes fully closed.
There is a one minute time limit while the shading is in fine adjustment mode. The shading must 
be moved at least once during each minute to prevent the mode from timing out.
1. On the remote, press the group number of the shading (1–6), then press the    left arrow to 

fully lower the front shading and close the vanes (the rear shade is fully raised).

2. While pressing the programming button on the shading, press the    left arrow on the remote, 

then release the programming button on the shading. The programming button light will turn 
on solid red to indicate the shading is in fine adjustment mode.

NOTE:

  If the shading moves, or the programming button flashes green, repeat steps 1  

  and 2.
3. Use 

▲

 OPEN, 

■

 STOP, and 

▼

 CLOSE on the remote to lower the shading or raise the 

shading as far as possible without opening the vanes. The shading will move in slow speed 
while in fine adjustment mode.

NOTE:

  In the vanes closed position, the bottom rail will be slightly raised from the window 

sill, which is normal.

4. Set the new adjustment position. Press and hold 

■

 STOP on the remote for approximately  

6 seconds, until the indicator lights on the remote start blinking.

5. Save the new adjustment position and exit fine adjustment mode. While pressing the 

programming button on the shading, press the    left arrow on the remote, then release the 
programming button. The red light turns off, the green light flashes twice, and the shading 
moves slightly twice to confirm that the new setting was accepted.

6. Exit program mode on the remote. Press and hold 

■

 STOP on the remote until the indicator 

lights on the remote stop blinking (approximately 6 seconds), or let the remote time out 
(approximately 20 seconds).

7. Test the shading to confirm the new adjustment position.