OPERATION
22
Problem
The shading raises or lowers unevenly, the fabric rubs against one end of
the headrail, or the bottom rail is uneven when fully raised.
Solution
Check that the window is square by measuring the diagonals.
Check that the installation brackets are level. Shim (not provided) to level, if
necessary.
Check that the limit stops are adjusted the same and are not too tight.
Perform a skew adjustment for the front shading or rear shade. See below.
Adjust the Bottom Rail Weight of the Front Shading
■
■
Flip up the bottom rail to access the bottom rail weight.
■
■
To release the weight clip, insert a flat blade screwdriver into the weight clip
and turn clockwise.
■
■
Move the weight in 1" increments
toward the side where the fabric
is gathering.
■
■
Secure the weight clips in position by turning them counterclockwise after
making the adjustment.
■
■
Test and, if necessary, adjust again.
Apply Skew Adjustment Tape to the Rear Roller Shade
Using the tape strips and instruction guide in the Skew Adjustment Kit included
with your order, place the tape strips onto the window side of the rear roller
shade fabric. The number of tape strips and their placement depends on the
type and severity of the skew, as explained in the instruction guide.
Weight
Weight
Clip
Weight
Clip
Fabric Roll
Move Weight
Tape
Strips
Summary of Contents for Silhouette Duolite Window Shadings PowerView Motorization
Page 34: ...Notes...
Page 35: ......
