INSTALLATION
9
Tab
Battery
Wand
Squeeze
Cap Latch
Slot
STEP 3: PowerView
™
Only — Connect the Power Source
NOTE:
When power is connected to the motor, a green LED inside the manual control button
housing will flash to indicate the shading is ready for operation.
■
■
Refer to the appropriate page based on your order.
■
➤
For a battery wand, see below.
■
➤
For a satellite battery pack, see page 10.
■
➤
For an 18V DC power supply, see page 11.
■
➤
For a C-size satellite battery wand or large DC power supply, see the instructions that
came with the unit.
Battery Wand
Install the Batteries into the Battery Wand
NOTE:
Hunter Douglas recommends AA alkaline batteries for use with our battery-powered
shadings. These will provide more than one year of operation, depending on usage. Lithium and
rechargeable batteries are not recommended.
■
■
Squeeze the cap latch to release and remove the cap.
■
■
Install the batteries according to the
instructions on the battery wand label.
■
■
Replace the cap.
■
➤
Align the tab with the end of the wand
and press the cap on until it latches.
Mount the Battery Wand into the Battery Wand Clips
■
■
Position the battery wand with its socket toward the motor end
of the shading.
■
■
Push the battery wand straight up into the battery wand clips
until it snaps into place. Check to make sure the battery wand
is secure.
CAUTION:
Be sure the cables do not become pinched by the
battery wand clips during installation. Damage or overheating of
components could result.
Plug the Power Cable into the Battery Wand
■
■
From the back of the shading headrail, connect the
power cable (from the motor side) into the socket on the
battery wand.
Proceed to “STEP 4: Install the Optional Back Cover (If Applicable)” on page 12.
Power
Cable
Battery
Wand
Socket Toward
Motor End
