OPERATION
14
PowerView
™
Motorization
Test the Shading
Use the manual control button to test the shading and
ensure that the motor and power source are working
correctly.
■
■
Press and release the manual control button to
lower the front shading and rear shade. If the
shading does not operate, see “Troubleshooting”
on page 18.
■
■
After the shading and shade are fully lowered, press
and release the manual control button again to raise
the rear shade and front shading.
CAUTION:
When raising the shade and shading for the first time, observe how the fabric
rolls up into the headrail. It should roll up evenly. If the bottom rail is not level or the fabric
starts to rub against either window jamb, immediately press the manual control button to
stop the shading. See “Adjust the Bottom Rail Weight” on page 19.
Using the PowerView Remote
Refer to the illustration on the following page to familiarize yourself with the controls on the
remote. Activate the remote by pulling both plastic tabs from the back battery compartment.
IMPORTANT:
If you have more than one remote, see “Adding Additional Remote(s) to the
PowerView
™
Shade Network” in the
PowerView Motorization Remote Control Guide
.
Pull the cord
to the center,
listen for the
“click,” and
release the
cord.
To stop while
lowering,
slightly tug
the cord
straight down.
Pull the cord
down in long
even strokes.
Allow the cord
to retract
between
strokes.
1
Lower
Shading
Open
Vanes
Lower
Rear
Shade
2
Raise
Rear
Shade
Close
Vanes
Raise
Shading
UltraGlide
®
2 Click and Walk Away
™
Operation