OPERATION
15
Joining a Shading to a Group
IMPORTANT:
The shading will not operate using the remote until it has been joined to a group.
1. Press and hold
■
STOP for 4 seconds to put the remote in program mode. The lights on the
remote will flash to indicate it is in program mode.
2. Press the desired group number (1 – 6) on the remote. The backlight for the group number
will flash to show it is selected.
3. Press and hold the manual control button on the shading.
4. While continuing to press the manual button, press
▲
OPEN on the remote. The shading will
move slightly to indicate it has joined the group. Release the manual control button.
5. Press and hold
■
STOP for 4 seconds to exit program mode. The lights will stop flashing.
Basic Operation
1. To wake up the remote, simply pick it up or press
■
STOP. The last group(s) selected will be
highlighted and active.
2. Press “all” or groups 1 – 6 to select specific shading(s) to move. Selected group button(s) will
light to show they are selected.
a. Multiple group buttons may be selected at a time.
b. To deselect a group, press the group button again. The backlight for that group button
will go out.
3. Press
▼
CLOSE to lower the front shading.
4. Press the right arrow to open the vanes.
5. Press the left arrow to close the vanes.
6. With the vanes open, press
▼
CLOSE to lower the rear shade.
7. Press
▲
OPEN to raise the rear shade. Press
▲
OPEN again to raise the front shading.
8. Press
■
STOP to stop shading or vane movement anywhere along its travel.
Group 1
Group 2
OPEN
CLOSE
Group 3
Group 4
Group 5
Group 6
Favorite
(Shading/vane position)
LEFT ARROW
Tilts vanes closed
RIGHT ARROW
Tilts vanes open
STOP
(Press and hold for
programming mode)
