OPERATION
40
■
Unfold the fabric and carefully remove the
plastic strip from the panel. Save it for
later use.
Holding the bottom end of the panel fl at,
■
mark the distance (previously recorded) at
several locations across the bottom of the
panel. Using a straight-edge, draw a line connecting these marks.
Using a sharp pair of scissors, carefully cut straight across each panel along the line to
■
remove the desired length from each panel.
Place the previously removed plastic strip along the bottom of the panel back, aligning the
■
strip with the bottom edge of the panel. Push on the plastic strip so it adheres to the panel.
Carefully crease the panel along the upper edge of the strip.
■
IMPORTANT:
Make sure there are no ripples in the fabric panel.
Holding the folded panel and plastic
■
strip, carefully insert the panel into the
bottom weight until it is fully seated
within the bottom weight.
CAUTION:
Be careful NOT to pull on
the fabric, as it can cause permanent
distortion or damage.
Re-install the snap slide end cap.
■
Summary of Contents for Skyline Gliding Window Panels
Page 1: ...Installation Operation Care Skyline Gliding Window Panels...
Page 54: ...Notes...
Page 55: ......
