OPERATION
49
Problem
Solution
The panel does not hang
correctly.
Check that the panel is installed correctly. Panels should
■
be angled compared to the track, with each panel
hanger connected to a carrier in both the front and
back channels.
Check that the headrail is level.
■
Check that the bottom weight snap slides are installed
■
and operating correctly. The bottom weights should slide
together easily when connected using the snap slides.
Check that there are no obstructions to the movement
■
of the panels. Replace protruding window cranks
with T-cranks.
Check that the Universal Cord Tensioner (if not wand
■
control) is installed properly and that the cord does not
interfere with the hanging panel.
Wrinkling and folds in the panel fabric, due to packaging,
■
will usually drop out within a few days. See
Straighten
Panel Fabric From Bottom Weight
, page on 36, for
adjustment, if necessary.
The UCT has climbed into
the headrail.
Pull down on the plunger to free the cord and slide the
■
Universal Cord Tensioner to the bottom of the cord loop.
Properly mount the Universal Cord Tensioner. See the
Universal Cord Tensioner Installation Instructions
.
The UCT grabs onto the
cord upon operation.
Check that the universal cord tensioner is mounted
■
properly. Reinstall, if necessary.
Summary of Contents for Skyline Gliding Window Panels
Page 1: ...Installation Operation Care Skyline Gliding Window Panels...
Page 54: ...Notes...
Page 55: ......
