INSTALLATION
7
■
Attach the installation/extension brackets using the screws
provided.
CAUTION:
The rear of the installation brackets must be flush
against a flat mounting surface. Do not mount installation
brackets on
curved molding.
■
When using extension brackets, attach the installation brackets
using the screws and
speed nuts provided.
Install the Shade
■
With the headrail slightly tilted,
insert the front lip of the headrail
onto the front lip of the installation
bracket.
■
Push the headrail back and up until
its bottom lip snaps into bottom tab
on the installation bracket.
Attach the Hold-Down Brackets (Optional)
Hold-down brackets may be used with outside mount shades only.
■
With the shade fully lowered, insert the pin on the
hold-down bracket into the hole on the bottom rail
end
cap.
■
Mark the hole locations on the mounting surface.
■
Position the hold-down brackets over the mounting
hole locations and check their alignment. Attach using
two
screws.
IMPORTANT:
Disconnect the bottom rail from the hold-
down brackets to raise the shade.
Insert Front
Lip of Headrail
onto Bracket
Bottom
Tab
Push Up
and Back
Summary of Contents for Solera EasyRise
Page 1: ...Solera Soft Shades EasyRise UltraGlide and LiteRise Lifting System Installation Operation Care...
Page 17: ......
Page 18: ......
Page 19: ......
