INSTALLATION
4
Mount the Installation Brackets — Inside Mount
■
Mark 2" in from each jamb for bracket location.
➤
If more than two installation brackets came with your order, space additional bracket(s)
evenly between the two end brackets. Mount into wood whenever possible.
➤
Allow a minimum of 15" between bracket center lines (motor side) for the battery wand.
■
Two-On-One Headrail shades:
Place installation brackets 2" on each side of the panel split.
■
Center the brackets on your marks and
mark the location of the screw holes.
➤
Allow
3
/
4
" space behind the brackets
for rear fold clearance. (This also
provides battery wand clearance.)
➤
With this
3
/
4
" allowance, the minimum
casement depth required to mount the
installation brackets is 1
5
/
8
".
➤
The minimum casement depth to fully
recess the shade is 2
3
/
4
".
IMPORTANT:
The front edges of the
installation brackets must be level and aligned.
■
Pre-drill the screw holes using a
3
/
32
" drill bit.
CAUTION:
Use drywall anchors when mounting
into drywall.
■
Use a level to check that the mounting
surface is level. Shim (not provided) the
brackets if necessary.
■
Attach the installation brackets using the
screws provided.
Proceed to “STEP 2 — Install the Shade” on page 8.
2"
Space Evenly
Jamb
Jamb
Space Evenly
(15" Minimum for Battery Wand
at Motor End)
2"
2¾" Fully
Recessed
Depth
2"
2"
2"
Space Evenly
Jamb
Panel Split
Jamb
Space Evenly
2"
Motor
Side
Motor
Side
