INSTALLATION
5
Mount the Installation Brackets — Outside Mount
IMPORTANT:
Spacer blocks are recommended for the
3
/
4
" rear fabric fold clearance or with
shades using a battery wand (see spacer block attachment on the following page).
■
Center the headrail over the window opening at the desired height. Use a pencil to lightly
mark the mounting surface at each end of the headrail.
➤
Alternatively, measure the width of the headrail and use that width to mark the headrail
end points over the window opening.
■
Mark 2" from each end of the headrail.
➤
If more than two installation brackets came with your order, space them evenly between
the two end brackets and mark their location. Mount into wood whenever possible.
➤
Allow a minimum of 15" between bracket center lines (motor side) for the battery wand.
■
Two-On-One Headrail shades:
Place installation brackets 2" on each side of the panel split.
■
Center the brackets on your marks, then mark each of the screw holes.
➤
A minimum 1" flat vertical surface is required to mount the brackets.
➤
The top of the installation brackets or extension brackets should be at the desired shade
height.
The brackets must be level and aligned.
➤
When using extension brackets, mark two screw holes per bracket.
CAUTION:
The rear of the brackets must be flush against a flat mounting surface. Do not
mount brackets on curved molding. Shim (not provided) the brackets if necessary.
Headrail
End Mark
Headrail
End Mark
Window Opening
2"
Space Evenly
Space Evenly
(15" Minimum for Battery Wand
at Motor End)
2"
Headrail End Marks
Motor
Side
Motor
Side
Window Opening
Panel
Split
2"
2"
2"
Space Evenly
Space Evenly
2"
Extension
Bracket
Installation
Bracket
