18
Reduced Combustion
In order to shut down the stove, push the air control lever fully in and slide fully to the left. If the controls are
left in this position, the fire will be starved of air and will die down. If you want to revive the fire, pull the air
control lever fully out and slide fully to the right. For normal burning push lever all the way in and leave it
pushed to the right.
Warning! - The stove will remain hot for a considerable time after the fire has been extinguished.
Notes on Woodburning
With a full load of wood, the stove will need to be refuelled approximately once every hour. Wood can be
stacked in the stove, but no higher than the door handle.
Overloading the stove can cause excess smoke to be emitted. Wood burns most efficiently with the air control
primary air closed and secondary air open.
Wood burns most efficiently on a bed of ash and it is therefore only necessary to remove surplus ash from the
stove occasionally.
If there is insufficient burning material in the fire bed to light a new fuel charge, excessive smoke emission can
occur.
Refuelling must be carried out with a sufficient quantity of glowing embers and ash, so that the new fuel
charge will ignite quickly. If there are too few
embers, add some kindling to prevent excessive smoke.
When refuelling, it is important to have a damper in the open position if you have one.
Maximum Log Length: 350mm
Ensure your logs are well seasoned with a moisture content of less than 20%
Recommended Fuels
Hunter Stoves Group recommend that only wood logs with a moisture content of less than 20% should be
burnt on this appliance.
Burning wet or unseasoned wood will create excess smoke emissions, tar deposits in the stove and chimney
and will not produce a satisfactory heat output.
WARNING - DO NOT BURN BITUMINOUS COAL, PETRO-COKE, OTHER PETROLEUM BASED FUELS OR TREATED
WOOD SUCH AS PALLETS AS THIS WILL INVALIDATE THE PRODUCT WARRANTY. HOUSEHOLD WASTE MUST
NOT BE BURNT ON THIS APPLIANCE.
A list of approved fuels can be found at:-
HETAS Ltd
–
Telephone 01242 673257
–
http://hetas.co.uk/public/hetas_guide.html
Solid Fuel Association
–
Telephone 0800 600 000
–
MAINTENANCE AND SERVICING
WARNING!
NO unauthorised modification of this appliance should be carried out.
Important!
In order to ensure continued compliance with current Building Regulations and Local Authority Byelaws, this
appliance requires regular maintenance by a competent person. N.B. Refer to
the ‘Removing Internal
Components’ section of the installation instructions for det
ails on how to remove each component.
