20
Changing The Door Handle
Rope
Check the rope around the door. If rope is becoming detached, use rope glue to reattach it. If the rope is in a
poor condition, a replacement rope kit may be ordered from the Hunter Stoves Group spares range.
Chimney and Flue ways
It is important that the chimney, flue ways and any connecting flue pipe are swept regularly. This means at
least once a year for smokeless fuels and at least twice a year for wood and other fuels. The baffle will need to
be removed from its supports in order to sweep the chimney (see assembly instructions). Only wire-centred
sweeps’ brushes fitted with a guide wheel should be used. If it is not possible to sweep all par
ts of the chimney
through the appliance, ensure there is adequate access to cleaning doors. If the stove is fitted in place of an
open fire, then the chimney should be swept one month after installation to clear any soot falls which may
have occurred due to the difference in combustion between the stove and the open fire.
Annual Service
Hunter Stoves Group recommend that this appliance is serviced annually, preferably prior to the start of the
heating season, thus avoiding any delay in receiving replacement components, should you need them.
If you feel unable to undertake this task, Hunter Stoves recommend that you contact the installation engineer
for advice.
Remove all the internal components:
Log retainer, bricks, ignition air bar & baffle. Clean them with a soft brush and inspect them for damage.
Sweep the chimney/flue system if necessary. Clean down the internal surfaces of the appliance using a scraper
or wire brush.
Inspect these surfaces for damage/corrosion. If corrosion or damage is found, we advise that you consult with
your installer about rectification/repair. Brush out or vacuum the inside of the appliance and re-fit the internal
components.
Inspect the Glass and Gasket. Clean the Glass with a non-abrasive cleaner if required. If the Gasket is torn or
damaged, we recommend that is replaced to ensure that no products of combustion enters the room when
the appliance is used.
Painted Finish
Use a dry microfibre cloth or dry soft brush to clean the outer surface and touch up the paint if necessary.
Burn the appliance at a low rate, after maintenance, to allow any new seals, paint or glue to cure properly.
The appliance may emit unpleasant odours during this process, please ensure the room is well ventilated.
The paint can be ordered through our website www.hunterstoves.co.uk.
Remove screw holding in door hook with a flat
head screwdriver. Pull hook out of hole in door.
To change the door handle. Use a 5mm Allen Key to
undo the screw. Once screw is removed handle will
come off. To attach work in reverse.
