EN
45
4)
Check of functioning of the panel and the thermal probe
5)
Check of efficiency of the electrical system
6)
Cleaning of the evaporator
7)
Cleaning of the condenser
Cleaning of the evaporator
The evaporator requires periodic cleaning.
!
Since evaporator fins are sharp enough, always use protective gloves. Only the brush can
be used for cleaning! Never wash the evaporator under running water or using sharp objects.
To arrange the access to the evaporator:
1. Open the door of the device chamber (A);
2. Loosen two screws (B) of the reflector on the right;
3. Remove the guides (C);
4. Turn the reflector (D) to the left.
Cleaning of the condenser
The condenser requires periodic cleaning.
!
Since condenser fins are sharp enough, always use protective gloves. In case of
accumulation of a large amount of dust, also use the face mask and goggles.
If dust accumulates on condenser fins, use a vacuum cleaner or a brush to carefully remove
it with vertical forward movements.
Never use any other cleaning tools, otherwise condenser fins can be damaged and the device
efficiency can be reduced.
To clean the condenser:
1. Open the door of the device chamber (A);
