EN
59
To exit the menu, simultaneously press 2 buttons
or wait 5 sec.
Setting temperature holding at the end of the cycle:
if a certain temperature is to be retained at the end of the cooling cycle, press and release
button. The preset holding temperature at the end of the cycle (HdS=holding
setpoint) will be displayed for 5 sec.
To edit, during the display of the preset temperature press and hold
button until
HdS message flashes. Then use
arrows to edit. To confirm the set data,
press
button again.
To remove temperature holding at the end of the cycle, just set HdS=OFF.
After completion of the cooling or freezing cycle the device switches to the temperature
holding cycle. This phase can be easily distinguished by the active
H
icon.
10.3.4.
Defrosting
The defrosting function is determined by idF parameter. During defrosting, the minimum
and maximum temperature alarm is disabled.
Before activating defrosting, make sure that none of the cycles is started.
To activate the defrosting function, press and hold
for 3 sec.
The defrosting cycle is completed:
➢
when the maximum set defrosting cycle time has elapsed;
➢
when the temperature of the evaporator sensor has reached the set value;
10.3.5.
Drainage
Wait for a while at the end of the defrosting cycle until the drainage time elapses. All settings
relays are disabled, and
indicator flashes. The drainage duration can be adjusted by Fdt
parameter.SPECIFICATIONS
Model
HKN-
BCF3L
HKN-
BCF5L
HKN-
BCF3
HKN-
BCF5
HKN-
BCF10
HKN-
BCF14
