EN
19
Step 1
Place the machine on a flat, stable surface. Hold and tighten the bottom screw until the
machine fits firmly on its support. Insert the plug into the wall socket.
Step 2
Connect the CO2 valve. Keep the valve closed; for safety, the valve should be blocked with a
steel wire. Now, insert the rubber seals inside the nut and use the supplied wrench to
tighten the nut until it stops. Then use the wrench to secure the nut and valve.
Step 3
Press down on the flexible gas hose until gas begins to flow from the cylinder. Now put the
glass under the gas sprayer and hold it for 5-6 seconds to cool it down.
Attention!
Connect the machine only to an earthed socket with frequency and voltage matching
the frequency and voltage specified for the motor!
Before using, make sure that the cable and socket are dry and clean!
Do not allow the switch to come into contact with water, keep it dry!
GAS CYLINDER REPLACEMENT
