EN
36
2.3.5.2 Hot Water
Steam/Hot water pipe [3] is separated from coffee spout [5]. Hot water can be used for
making tea, instant soup and so on. Place a cup under the pipe [3], and then refer Fig.2 to
switch to hot water mode. Press
“
Hot Water
”
button
to start producing hot water.
The temperature of hot water can be adjusted by continuously pressing
“
Hot Water
”
button
during this period, there are three grades available. The maximum production of hot water is
250 ML.
2.4 SUGGESTIONS
2.4.1 Pre-warm cups
Place cups above the cup warming plate [7] to warm them up.
2.4.2 Adjust coffee grind thickness
Grinding grade need to be adjusted either the coffee flows out
too fast (coffee granules are too big) or too slow (coffee granules
are too small).
The adjustment only can be made during grinding,
otherwise the machine will be damaged.
The recommended grade is 2.
Turn the powder thickness adjust knob [11] to a lower
number if the coffee granules are too big, turn the powder
thickness adjust knob [11] to a higher number if the coffee
granules are too small.
2.4.3 Adjust the height of coffee spout
Move the coffee spout up and down to make the spout a
little higher than the cup so as to keep the aroma of the
coffee.
2.4.4 Pre-marinate coffee powder (Pre-brewing coffee)
The pump will stop for 2 second after the coffee powder has been wet, then continue.
2.4.5 Coffee bean storage
To make sure that the coffee bean or coffee powder is fresh, put coffee bean into a sealed
container, then put the container in a shady and cool place.
2.4.6 Water quality
Besides the coffee beans, grinding and water temperature, water quality is also important.
Place a cup under the
steam/hot water pipe [4]
Turn the knob to hot
water position
Press the hot water button
The recommended
grade is "2"
Adjust height of
coffee spout
