Remote Control
• Select a mounting location best suited to your particular needs.
• Surface Mounting: Mark the position. It is good practice to use tape on
the surface to be drilled then drill the hole through the tape. This will avoid
scratching/chipping of the surrounding surface.
• Trim Tab Mounting: Install your lights by removing the screws on the bot-
tom of each trim tab ram (Bennett), insert bracket and tighten screws. Brack-
ets are universal for other planing systems. Ensure your tabs are completely
in the down position when installing to allow for ample cord length.
• Fit wiring: Before proceeding to drill the above waterline wire holes,
check carefully to ensure that it will not affect the operation of other equip-
ment in close proximity, nor compromise the integrity of the structure.
• After drilling the holes apply a marine grade sealant, 3M 5200 is recom-
mended, in the holes to ensure it is completely sealed against the ingress
of moisture between lamination. Attach light and allow sealant to cure.
• Use either cable clams or apply a marine grade sealant to fill the holes
to ensure it is completely sealed against water intrusion.
• Use wire ties to ensure cables will not chafe or kink. Wire loom can be
used for barnacle protection.
• All wiring must be carried out by a suitably trained/qualified electrician
using ABYC guidelines. With low voltage DC wiring the risk of fire may be
present if wiring is not correctly installed.
• Ensure power supply wiring is of the correct size for the current draw.
Ensure wire harness will not chafe.
• Use only approved marine grade
water-tight connectors and wire. All
joints must be soldered and sealed
with a proprietary compound filled heat
shrink tube.
• Ensure electrical supply has suitably
sized fuse or other protective device to
provide adequate protection of wiring
and connected equipment in the event
of circuit fault or short circuit.
• Dismantling of this product voids
warranty.
• Do not use as a step.
Hint:
Spraying lights with Silicone or
putting a thin layer of petroleum Jelly
on annually will help keep algae, mus-
sels, barnacles, etc. off.
Bennett Tabs
Shown
Remove the 1/4”-20 x 3/4” phillips
Head Machine Screw from lower
hinge. place Trim Tab Brackets on
and reinstall screws. Different hole
patterns for other leveling systems.
Note:
Make sure Hinge Screws are long
enough as so they will not allow Hinge pin
to slip out.
Vessel Installation Instructions
Notes
Hurley Marine
