Control Box
Troubleshooting
Main Power
Rocked Up “On” rocked down “Off”.
LED Status Light
Indicates light(s) are working.
Remote Module
2 amp fuse.
5 Amp Fuses
Each fuse used for one Light / Line.
Line 1, 2, 3 & 4
One light per line. (Red+ / Black -)
Main Power In
10 -30 volt dc power in. (Red+ / Black -)
Daisy Chain Cable
Used to add an additional Control Box and up 4 more RGB Sea-Vue Lights or to
add a Hurley Music Controller.
Remote Pairing
Remote pairing and synchronizing additional remotes. Switch to “Off” (down position)
for 5 seconds, then within 2 seconds of switching “On” press the “Speed +” button on
the remote.
Operation
With standard installation completed begin by powering up the RGB Control
Box and ensure proper operation of the Hurley Marine RGB Sea-Vue
TM
Underwater Lights utilizing the provided RF Remote Control.
Take a moment to ensure all remote functions are properly working. Enjoy!
Lights do not turn on:
Check all wiring connections and fuses. Make
sure voltage is between 10–30 VDC. Ensure the “Main power” switch
and “Remote pairing” switch are in the “On” position.
Provided remote control not working:
Check the state of the remote
control batteries. Ensure not out of range when attempting to use re-
mote. Make sure the “Remote pairing” switch is in the “On” position.
Adding a new RF remote to control the lights:
With the Control Box
turned “On” and new RF remote in hand slide the “Remote pairing”
switch, located inside the Control Box, to the “Off” position for 5 sec-
onds, then within 2 seconds of sliding the “Remote pairing” switch to
the “On” position press the “Speed +” button on the new remote. If the
pairing was successful all lights will flash white 3 times. If the lights do
not flash 3 times repeat the procedure. If the lights flash white 10 times
all RF remotes will need to be re-paired to the Control Box.
When attempting to pair a remote the lights blinked white 10 times
and now none of the remotes including the app are working:
If a
remote was already paired with the Control Box attempting to pair the
remote will actually clear all paired remotes. This is indicated by the
lights flashing white 10 times. In this case all RF remotes will need to
go through the pairing procedure in order to reconnect them to the Con-
trol Box.
Lights seem dim:
Check lenses for growth and/or debris and clean if
needed. Light may be overheating which by design will cause the lights
to dim in order to keep from damaging any components. Ensure suffi-
cient water is in contact with the lights.
R
G
B
Sea-Vue
TM
RGB Control Box can
accommodate up to
4 RGB Sea-Vue
TM
Lights.
Hurley Marine
