HUROM M100 Series, Instruction Manual

14

10. How to Clean Juicer 

After the product stops operating completely, pull out 

the power cord with dry hands. Even after the product 

is stopped, the motor will slowly come to a stop so, 

after the operation stops completely, wait about 3 

seconds before detaching the chamber set.

01 

Detach the chamber set from the product body. 

Turn the hopper to open it and then sequentially pull 

each of the parts to disassemble them.

02 

Wash the parts with a cleaning brush under running 

water.

03 

Open the discharge cover and juice cap to clean the 

chamber.

04 

Wipe the product body with a damp towel or soft 

cloth.

05 

Detach and wash silicone packings after use. 

- Residues may still be stuck. (hopper packing, juice cap 

packing, extraction packing, seal packing, chamber 

packing)

06 

You can sterilize the parts by soaking them in warm 

water diluted with baking soda, citric acid or vinegar.

※

 Failure to clean the product immediately after use 

may cause its stainless steel parts and other parts to 

corrode or become discolored due to salt and pulp from 

the ingredients. Also, contaminants may be dried up 

and stuck inside, which makes it difficult to disassemble 

and clean them and may also cause performance 

impairment. Be sure to clean and air-dry it completely 

immediately after use and store it in a clean place. For 

long-term storage, use a cleaning brush to wash it. Do 

not clean with boiling or high-temperature water or use 

a cleansing sponge, steel sponge, abrasives and other 

sharp cleaning tools. Do not place it in a dishwasher or 

dish dryer.

※

 If clean water is poured and shaken for washing, the 

pulp will come off more easily.