HUCIS-180
5533
“EGA Spółka z o.o.” Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-
200 Starogard Gdański tel/fax:+48 58 56 300 80
20
5 Working Advice
Apply the power tool to the screw/nut only when it is switched off. Rotating tool inserts can
slip off. The torque depends on the impact duration. The maximum achieved torque results
from the sum of all individual torques achieved through impact. The maximum torque is
achieved after the impact duration of 6
–10 seconds. After this duration, the tightening
torque is increased only minimally. The impact duration is to be determined for each
required tightening torque. The actually achieved tightening torque is always to be checked
with a torque wrench.
When working with an application tool, pay attention that the application tool is firmly seated
on the tool holder. When the application tool is not firmly connected with the tool holder, it
can come loose again and not be controlled.
6 Battery capacity indicator
The 3 color LEDs will indicate the status of battery capacity as soon as you press the
ON/OFF switch (3).
All LEDs illuminate:
The battery is fully charged.
The yellow and red LED illuminate:
The battery has an adequate remaining charge.
Red LED:
The battery is empty, recharge the battery.
7 LED lamp
The LED lamp (8) can be used in poor lighting conditions to illuminate the area where you
want to drill or screw. The LED lamp (8) will be lit automatically as soon as you press the
ON/OFF switch (3)
10. Cleaning
•
Keep all safety devices, air vents and the motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device immediately each time you have finished using
it.
•
Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic parts of the equipment. Ensure that no
water can seep into the device.
Summary of Contents for 5533
Page 2: ......
