www.spartacogroup.com
800-860-6170
8
OPERATING INSTRUCTIONS
MAINTENANCE AND INSPECTION
1. Daily maintenance is required to ensure that the tool is kept in good working condition.
2. Sharpen blades occasionally with a sharpening stone on the back side of the blades to
remove any burrs that may occur.
3. Do not store the tool in a humid environment.
4. Wipe away any excess oil with a soapy cloth.
5. Provided that maintenance of the tool is carried out regularly, the tool should provide
many years of service.
6. Should you experience any difficulty with the operation and maintenance of this tool,
contact Huskie’s technical support department at 1-800-860-6170.
RIGHT
WRONG!
CUTTING
1. Retract blades by pressing the release button.
2. Be sure that material being cut is within the specified cutting capacity of the tool.
3. Place the material to be cut between the blades and press the advance trigger until blades
hold the material in place.
4. Check material for proper alignment to the cutting blades. It should be at a 90° degree
angle to the blades. Any other angle will cause the blades to spread apart and possibly break.
5. Continue to advance the blades until the material is cut. If material is cut and tool has not
yet by passed, it may be difficult to retract blades. If this occurs, continue to advance tool and
build pressure. A series of clicks will be heard while the tool running in a “neutral” mode. This
indicates that the tool has built full pressure and bypassed and can now be released.
