11
STORAGE
1. Short
Term
If the hammer will not be used for periods of one week or more, the tool should be
removed from the hammer and grease must be applied to the piston bottom. The hammer
should be stored indoors standing vertically in the working position.
2. Long
Term
For storage of more than 2 - 3 weeks or where condensation or corrosion is prevalent
(salt-water areas) note the following instructions. Remove and clean the tool. Flush the
front cap with clean solvent or hydraulic oil. Coat the exposed portion of the piston with
grease, apply grease to the tool and re-install. Store the hammer vertically and away
from standing moisture. To start the hammer after long-term storage, remove the tool
and inspect the exposed portion of the piston for corrosion. If corrosion is found do not
use the hammer until the defective piston has been repaired or replaced.
TOOL REPLACEMENT
Table 1. Standard Tool Weights
WEIGHTS
HAMMER MODEL
kg lbs.
HH100 5
12
HH150-2 7
15
HH300-2 14
30
HH500-2 15
32
HH750-2 23
51
HH1000-2
37
82
Summary of Contents for HH100
