24
COMPONENT
WEAR LIMITS (Continued)
Tool set pin
If .080 in. (2mm) of wear in the diameter is observed, a new tool set
pin is required.
Front cap
If the corner of the front cap is worn to the edge of the front cap
bushing, a new front cap is required.
Piston
When indentation or serious damage on the piston surface is
observed, a new piston is required. (Approximately 2,000 hours of
use).
Figure 17. Wear Limit Points
Table 9. New Component Dimensions
PART
*HH100 HH150-2 HH300-2 HH500-2 HH750-2 HH1000-2
Front Cap
Bushing I.D.
41. mm.
1.614 in.
51. mm.
2.008 in.
61. mm.
2.402 in.
66. mm.
2.598 in.
76. mm.
3.0 in.
91. mm.
3.583 in.
Shank
Bushing I.D.
41. mm.
1.614 in.
51. mm.
2.008 in.
61. mm.
2.402 in.
66. mm.
2.598 in.
76. mm.
3.0 in.
91. mm.
3.583 in.
Tool O.D.
40. mm.
1.575 in.
50. mm.
1.768 in.
60. mm.
2.362 in.
65. mm.
2.559 in.
75. mm.
2.953 in.
90. mm.
3.543 in.
* HH100 does not have replaceable bushings. Measurements refer to the front cap itself.
ASSEMBLY
Note:
Clean every part before assembly. Keep parts clean and do not scratch during
assembly. Assembly can basically be done in the reverse order of disassembly. Make
sure parts are installed in the correct direction.
Summary of Contents for HH100
