Huskie Tools RCC-MK754ACM, Operator'S Manual

MODEL: R

C

C-MK754ACM

At this point, operator can safely remove themselves from the area or line of sight with the tool for actual 

operation. This will be up to each company for their own policy and procedures for remote cutting.

On the remote hand-held device, turn power switch to “ON” position. Confirm “power”, “blade engage” and 

“paired” LED’s are all illuminated.

To operate the tool to cut, press both buttons on the remote – no sequence is needed, as long as both 

buttons are pressed, the tool will operate. The tool with stop when one or both buttons are released.

The operator will know the cable is cut when the yellow “blade engaged” LED is off – this indicates the 

blade has completely gone through its arc and out the other side, leaving no chance the cable has not 

been cut. If LED is still illuminated, the blade has stopped, and cable is not cut. Cycle time should be 

approximately 15 to 20 seconds

.

9

OPERATING INSTRUCTIONS

2.

Power ON

Once tool is secured and blade is engaged, press the power switch "ON". the Green power LED and 

Yellow blade engage LED will illuminate. Then press the "CUT" switch. The tool automatically goes to 

the "OPEN" position each time it is powered up for safety.

Once the hand held remote is powered on, the blue "paired" LED 

will illuminate.

Be sure to check battery levels on both the tool and remote before 

operating.

Blade engage 

(yellow) 

and Pairing 

(blue) 

LED lights

3. Operate

Device Paired

 (blue)

Battery low 

(red)

Blade engaged

 (yellow)