3
http://www.huskietools.com
info@huskietools.com
1.
Select only the appropriate material to be cut. Cutting materials other than those specified will result in severe
tool damage and may cause personal injury. Consult factory if you have any questions about cutting capacities.
2.
Always cut the material at the 90°degree angle to the blades. Trying to cut at any other angle will cause the
blades to spread apart and possibly break.
3.
Always point the tool away from other people.
4.
If the tool is stored for an extended period at a temperature of less than 25º F (-5ºC), the tool should be allowed to
return to room temperature to ensure smooth operation Use the tool only after it has been at room temperature
for 1 hour.
5.
Do not drop the tool. Dropping the tool may damage the hydraulic circuit and result in the tool not functioning correctly.
6.
Keep the head and ram clean and free of debris. Solvents can be used to clean the head, but should not be used on
the plastic body. Use soap and water to clean the body.
1.
Do not short circuit the contacts or expose the cartridge to water, oil or solvents.
2.
Do not disassemble or attempt to repair the battery cartridge or dispose of in a fire.
3.
Do not drop or otherwise abuse the battery cartridge.
4.
Do not leave the cartridge in locations where it will be exposed to a temperature greater than 140ºF (60ºC) for an
extended period.
5.
The battery has a limited life. When the crimping capacity becomes about 1/2 that of the original capacity, the
battery should be replaced.
6.
If the battery cartridge is stored without being charged, natural drainage will cause the power to be reduced. The
battery should be charged every 3 months if not in use.
1.
The LED indicator lights up green and remains lit when the unit starts charging a battery cartridge. The indicator
turns orange when charging is completed.
2.
This unit is for charging battery cartridges BP-70E, BP-70EI, BP-70R, BP-70I and BP-70MH only. Do not use
the charger for any other devices.
3.
Allow battery cartridges to cool before charging. Allow at least 15 minutes between charges when charging sev-
eral cartridges in succession.
4.
Charge batteries at an ambient temperature of 50º-95ºF (10º-35º C). Charging time is approximately 25 minutes
for the BP-70E and BP-70EI, 15 minutes for BP-70R and BP-70I, and 35 minutes for the BP-70MH.
5.
Never short circuit the output terminals.
6.
Do not expose the charger to water, oil or solvents.
7.
Do not disassemble, attempt to modify, drop or otherwise abuse charger.
P
RECAUTIONS FOR THE BATTERY CARTRIDGE
:
P
RECAUTIONS FOR THE TOOL
:
P
RECAUTIONS FOR THE CHARGER
:
IMPORTANT OPERATING PRECAUTIONS
Summary of Contents for REC-434YC
Page 2: ......
Page 8: ...6 http www huskietools com info huskietools com MODEL REC 434YC PARTS DIAGRAM...
Page 11: ......
