Huskie Tools REC-434YC, Operating Instructions Manual

4

http://www.huskietools.com

info@huskietools.com

OPERATING INSTRUCTIONS

1.

Insert the plug end into a 120V power source. The LED indicator will
flash red indicating the charger is now in “stand-by” mode and ready to
charge the battery. Do not plug the charger into a generator as this will
likely cause the fuse in the charger to short, and will not operate.

2.

To charge a drained battery, insert the battery into the charger until the
LED indicator shows a steady green. This indicates the battery is being
charged and will be completed in approximately 25 minutes. The LED
indicator will show orange when charging is completed.

3.

If the indicator shows a steady red when the battery is inserted, the bat-
tery is too hot to be charged and must be cooled to room temperature before charging. Do not leave the battery in
the charger to cool as the charger will not recognize the battery is inserted and will not charge.

4. 

If the LED indicator goes out or is flashing quick red, this could be a possible short in the battery circuit, or a
problem with the charger itself. It is best to consult the factory at 1-800-860-6170 for service if such a condition occurs.

5. 

To recondition the battery, insert the battery into the charger and push the “R” button. The LED indicator should be
flashing green to indicate the discharge cycle is now in progress. The light will turn steady orange when complete
and the battery will have a full charge.

6. 

For technical questions or difficulty in operation, please call our customer service department at 1-800-860-6170.

ATTACHING THE BATTERY CARTRIDGE

TRIGGER AND RELEASE BUTTON

CHARGING THE BATTERY

1. 

The ram advances when the trigger is pressed and stops when the trigger is

released.

2. 

To retract the ram, press the release button. The ram continues to retract while

the release button is pressed.

1. 

While pressing the latch, pull out the battery cartridge. To replace the battery

cartridge, push the new cartridge firmly into place.

2. 

After inserting a battery cartridge, check that it is securely in place by pulling

gently. Do not press the latch when pulling the cartridge.