Huskie Tools REC-B634YC, Operation Manual

www.spartacogroup.com 

 800-860-6170

12

TROUBLESHOOTING GUIDE

PROBLEM

CAUSE

SOLUTION

MOTOR RUNS, BUT THE 

TOOL JAWS WILL NOT 

ADVANCE

Insufficient Hydraulic Oil

Consult Factory for Repair 

Service

Air Block in Hydraulic System

Invert tool to allow air to rise 

towards the top of the oil 

bladder

Defective Hydraulic Circuit

Consult Factory for Repair 

Service

MOTOR RUNS, TOOL JAWS 

ADVANCE, BUT WILL NOT 

BUILD PRESSURE

Insufficient Hydraulic Oil

Consult Factory for Repair 

Service

Defective Suction Valve or 

Bypass Cartridge

Consult Factory for Repair 

Service

MOTOR WILL NOT RUN AT 

ALL

Defective Battery

Charge or Replace Battery

Bad Contact or Loose Battery 

Connections

Check all Connections and 

Wires

Misaligned Switch

Check to Make Sure that 

Switch is Properly Aligned with 

Trigger
Consult Factory for Repair 

Service

TOOL JAWS WILL NOT 

RELEASE

Tool Did Not Complete a Full 

Cycle and Bypass

Press Trigger and allow Tool 

to Bypass, Then Release Tool 

Jaws

Connector is Jammed in Tool 

Jaws

Press and Hold Release Trigger 

While Prying Tool Jaws Apart

Release Trigger is Bent or Mis-

aligned

Consult Factory for Repair 

Service