8
Pre-Operation (continued)
Part
Description
I
Thermal Overload Reset:
This motor has a manual thermal overload protector. If the motor overheats
for any reason, the overload protector will shut off the motor. The motor must be allowed to cool down
before restarting. To restart:
1. Place the AUTO/OFF switch in the “Off” position.
2. Allow the motor to cool.
3. Depress the red reset button on the motor.
4. Place the Auto/Off switch in the “Auto” position to restart the motor.
J
Compressor Feet:
The compressor feet are used to stabilize the compressor and used as brackets when
mounting to the floor.
K
Belt Guard:
The belt guard is a protective enclosure for moving parts.
L
Pump Oil Fill:
The pump oil fill is used to add oil to the crankcase.
M
Pump Oil Drain:
The
pump oil drain is used to purge old oil from the pump. Loosening the drain plug will
allow oil to exit the pump crankcase.
N
Pump Oil Sight Glass:
The pump oil sight glass is a visual identifier for oil level in the crankcase.
O
Motor:
The motor is the drive component powered by electricity to rotate the pump by a belt pulley
system.
P
Air Outlet:
The air outlet is a connection point to provide useable air for the tools.
PLACEMENT OF THE AIR COMPRESSOR
WARNING
:
If any parts are damaged or missing do
not operate this product until the parts are replaced.
Failure to heed this warning could result in serious
personal injury.
CAUTION
:
Do not use in an environment that is dusty
or otherwise contaminated. Using the air compressor
in this type of environment may cause damage to
the unit.
NOTICE
:
Long lengths of electrical wiring could cause power loss
to the motor.
□
Place the air compressor in a clean, dry, and well
ventilated area.
□
The air compressor must be positioned at least 18
in. (0.5 m) away from the wall or other obstructions
that will interfere with the flow of air.
□
Locate the air compressor as close to the main
power supply as possible to avoid using long
lengths of electrical wiring.
□
The air filter must be kept clear of obstructions
which could reduce the air flow to the air
compressor.
18 in.
