How to use the pen
Your fex21 is supplied with a special pen or stylus with which to click on the
display screen icons to enable you to navigate through the application software
installed on your computer. You can also use your finger instead of the pen to
tap the screen. The pen is stored in the bottom of the computer, alongside the
standard serial port (COM1).
It is most important not to use a ballpoint pen or sharp-pointed object to click
on the display as this could cause damage to the surface of the screen.
How to enter data
To type numbers or letters, simply press the appropriate keys. To type a space,
press the large
µ
key at the bottom centre of the keyboard.
To delete characters you have just typed, press the
ü
(BACKSPACE) key.
To type capital letters or select the characters or functions shown at the top of
each key, hold down the
þ
(SHIFT) key and press the appropriate key.
If you want to type several capital letters, press the
…
(CAPS LOCK) key and
then press the appropriate letter keys. When you have finished, press the
…
key again.
To start a new paragraph or to enter data when you have finished typing it,
press the large
´
(ENTER) key.
How to move the cursor
You can move the cursor a character or line at a time using the four arrow keys
(
Š
,
ˆ
,
‡
&
‰
). To move the cursor up or down several lines, use
„
+
‡
together (to move up) or
„
+
ˆ
together (to move down).
To move the cursor to the beginning of the first line press the
„
+
‰
keys
together. To move to the end of the last line, press the
„
+
Š
keys
together.
How to reset your fex21
If your fex21 locks up or fails to operate, you may need to reset it in one of two
ways.
Soft RESET
First, press the
ù
key to switch off your fex21. Then press and hold down
both the
ú÷
and
úø
keys. Next, without releasing the contrast keys,
press and hold the
ù
key for 6-10 seconds. Finally, release all three keys -
your unit will perform a soft RESET. When you use Soft RESET you do not lose
the Windows CE registry and therefore your data is safe.