1
ADJUSTING THE EXHAUST
See Figure 5.
The adjustable exhaust on the top cap of the tool allows
the operator to direct the exhaust according to operator
preference. To adjust, turn the exhaust cap until the exhaust
blows in the desired direction.
WARNING:
Disconnect the tool from the air supply before leaving the
work area, moving the tool to another location, or handing
the tool to another person. Failure to do so could result
in serious personal injury.
CONNECTING THE TOOL TO AN AIR SUPPLy
See Figure 6.
DANGER:
Do not use oxygen, combustible gases or bottled gases
as a power source for this tool. The tool will explode and
cause death or serious injury.
This tool is designed to operate on clean, dry compressed air
at regulated pressures between 70 and 10 psi. The correct
air pressure is the lowest pressure that will do the job.
NOTE:
Air pressure that is higher than 10 psi may damage
the tool.
The tool and air hose must have a hose coupling that allows
all pressure to be removed from the tool when the coupling
is disconnected.
WARNING:
Always use a coupling that discharges all the compressed
air in the tool at the time the fitting or hose coupling is
disconnected. Using a coupling that does not discharge
the compressed air could cause unintended operation
and serious personal injury.
WARNING:
Do not climb rigging or scaffolding while carrying a tool
that is connected to an air hose. Doing so could result in
serious personal injury.
Connect the tool to the air supply with a 1/4 in. female quick
connector.
OPERATION
Fig. 6
aIR HoSE
ConnECToR
QUICK-ConnECT
aIR FITTIng
aDJUSTaBlE
EXHaUST
Fig. 5
DUST CaP
